|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Anti-Transpirants
Wilt Protection for Plants
|
|
|
|
Wilt-Pruf®
Excessive moisture loss in plants causes, stress, shock, wilting and plant failure. It strikes during periods of drought, or when the plant roots are disturbed during transplanting. It also occurs in winter when drying winds and frozen ground deprive plants of their natural moisture intake.
WILT-PRUF® acts as a protective coating, holding in moisture on plant foliage and stems, substantially reducing water loss during periods of plant stress. WILT-PRUF spray dries to form a clear, colorless, flexible, gloss film without interfering with plant growth or materially affecting respiration, osmosis, or photosynthesis.
WILT-PRUF is a natural product derived from the resin of the pine tree. WILT-PRUF concentrate and ready-to-use spray containers are not damaged by freezing or thawing when stored. They will not solidify when thawed, but must be shaken well before using.
WILT-PRUF is organic, biodegradable, non-hazardous, and is non-toxic to eyes and skin.
WILT-PRUF does not require registration with the EPA because they make no pesticidal claims. They also meet specifications with the FDA for use on edible crops. When WILT-PRUF is sprayed on plant surfaces, the water in our formula evaporates leaving a soft, flexible film which degrades one layer at a time when exposed to air and light. Only the surface layer is going through rapid polymerization. It powders away in microscopic flakes which are either washed or blown away, as the rest of the layers go through the same process until the entire film is weathered away. This normally takes about two months under hot, summer conditions and about four months under cold weather conditions.
WILT-PRUF protects valuable shrubs such as evergreens, rhododendrons, azaleas, hollies, boxwood, laurel, and many other ornamentals. These broadleaf evergreens have a natural ability to survive when normal water intake through the root system is curtailed such as in the winter when the ground is frozen or during drought. But if the plants have been recently transplanted or if they are exposed to severe drying winds or severe drought situations, they may not have enough moisture built up in their foliage to survive long periods without absorbing water. WILT-PRUF gives them enough added protection to see them through long or severe periods of water stress. Unsightly wind barriers may also be eliminated by protecting these plants with WILT-PRUF. |
|
|
|
|
|
|
WILT-PRUF concentrate may be easily mixed with water without continuous agitation. WILT-PRUF should be added to water, not water to WILT-PRUF. If separation should occur, container needs only to be stirred. Once mixed, WILT-PRUF may be sprayed with any pressure type trombone, pump, or power sprayer except hose end. Hose end sprayers will not produce the proper mixture of concentrate and water. The more pressure, the better the spray pattern! WILT-PRUF will not clog sprayers, nozzles, or lines. WILT-PRUF must be allowed to dry outdoors in daylight since it is a film forming polymer and needs ultraviolet rays in order for the spray to set up or polymerize.
Sprayers should be cleaned after each use by rinsing with water immediately after each use. Surfaces sprayed inadvertently may be washed immediately with warm water and a mild detergent. Dried film can be dissolved without difficulty using kerosene or mineral spirits. Over-spraying on cars, terraces, windows, etc. should be avoided.
When we say "spray at a dilution rate of 1:10 or 1:5" we mean to use one part of concentrate to five or ten parts water. A "part" may be a pint, a quart, a gallon, or any measured quantity.
For winter kill protection, spray in late fall at a dilution rate of 1:5 when temperature is above freezing so that spray will not freeze on foliage. When spraying on arborvitae, cypress, juniper, and cedar; be aware that if these species have not sufficiently hardened off for the winter whereby moisture retreats to the root system, moisture in plant cells could freeze and burst if early severe freezing weather should occur.
For drought, windburn, transplanting, and bulb storage protection - dip or spray to run-off at a dilution rate of 1:10.
For Christmas trees, wreaths, and greens spray as above. In all cases, WILT-PRUF must dry outdoors in daylight. WILT-PRUF will turn Blue Spruce green temporarily. Always follow instructions on label carefully.
WILT-PRUF is available at Home Harvest in a 14 ounce aerosol spray can, a 32 ounce ready-to-use trigger spray bottle, and a 16 ounce concentrate. |
|
|
|
|
|
|
Order #WIL14OZ
Wilt-Pruf
Anti-Transpirant
Aerosol
14 Ounces
16.95 |
|
Order #WILQTRTU
Wilt-Pruf
Anti-Transpirant
Ready-To-Use
Trigger Sprayer
32 Ounces
14.95 |
|
Order #WILPTC
Wilt-Pruf
Anti-Transpirant
Concentrate
16 Ounces
19.95 |
|
|
|
|
|
|
|
|
|
|
|
Vita-Grow
Concentrated
Anti-Wilt
Vita-Grow Concentrated Anti-Wilt Spray is a University tested foliar spray designed to keep plants from wilting when under stress. Once diluted and sprayed onto the plant's leaves, branches, stem and stalks, it forms a thin biodegradable protective film. AWS protects plants from losing water during propagation and transplanting, yet it allows the plant to breathe.
The plant's ability to retain water is extremely important when roots have not yet formed as adverse temperatures or drying winds (hot or cold) threaten a plant's survival. Also, because of it's non-offensive odor it is great for cut flowers, wreaths and Christmas trees. Mix 1 part AWS with 7 parts water. 16 ounce concentrate bottle. |
|
|
|
|
|
|
|
Order #VITGR16OZ
Vita Grow
Anti-Wilt Spray
Concentrate
16 Ounces
24.95 |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
